The Daily Maintenance Of The Round Bottle Labeling Machine Is Essential

- May 25, 2019-

When we use the round bottle labeling machine, sometimes the glue surface on the label is too smooth, the hardness of the label is too strong, the left and right claws of the label, the upper and lower claws are not aligned with the groove of the round labeling machine, the viscosity of the glue is not, so The constituting label cannot be half-sticked by the fan-shaped rotating rod. The cleaning method is to change the viscosity of the glue; replace the label material, the surface of the glue is rough; replace the paper with a soft texture, or wrap the label with a wet towel before use. Five minutes or so, making the label soft; adjusting the label's equipment;

The squeegee and the rubber roller can not appear empty space in the whole length. If there is empty space, the squeegee plate can be adjusted by adjusting the painful bolt; the rubber roller and the target plate are adjusted, and the target plate and the rubber roller are only in contact with each other without any pressure. . The vacant lot is too large, and the target plate is too glued to form a silicone. The vacant lot is too small, the contact is too tight, the glue will be squeezed away, and there is no glue on the half of the target.

When there is no label, the label platen can be pressed to the front end of the label box and the label near the label hook can not be crushed when the label is installed; the bottle star wheel is subject to the bottle star wheel groove. In the middle, adjust the auger of the round bottle labeling machine so that the auger is pressed against the bottle side without any displacement.

Round bottle labeling machine is necessary to carry out inspection work every day before, during and after the operation of the equipment. If there is an abnormal reaction until the technician performs maintenance during maintenance, the following are the routine maintenance operations:

1. After daily machine operation, first disconnect the power supply and wipe the surface of the machine, work table and other parts.

2, equipment requirements to ensure the use of the matching power supply voltage, in order to normal production.

3. Check the tightening degree of all bolt joints in punctuality. If it is loose, it should be tightened in time.

4, check the chain and other working parts, if there are shortcomings should be cleaned in time. And punctually make up the smooth oil, each gear meshing surface is punctual and add drip oil or butter smooth.

5, the positioning of each positioning, testing equipment, there should be no misplacement, if necessary, from the beginning.

6. Check whether the gas lines and joints are loose or falling.

7. Check if the belts are slipping.